Dan Michaels says:
"Math-Averse, Stupid Guy's, Hi-Speed 8-Channel PWM"
Use a lookup table.
The uC can't do anything else when it's running, and you may get a fairly-long pause every time you change one of the 8 duty cycle values, since you have to reload or recalculate the entire table.
On a 20 Mhz PIC, you could get rock-steady 8-channel PWM at maybe 1-2 usec/step, or 1953-3906 Khz for 256 steps.
Or switching to a 50 Mhz Scenix SX18, you can get rock-steady *7* bit 8-channel PWM at 200 nsec/step, or 39,062 Khz - limited to 7 bits since SX RAM = 128 bytes.; (send block to port B - 10 clocks/loop = 200 nsec). send_block jmp :L3 ; jump to re-start (initialization). :lp1 nop ; can insert code here for bailout. nop nop :lp2 setb FSR.4 mov w,IND mov rb,w incsz FSR jmp :lp1 ; jmp takes 3 clocks on SX. ; (reload - re-entry takes exactly 10 clocks). :L3 mov w,#bufstart mov FSR,w jmp :lp2
[sorry to inject heretical scenix code into the PIC universe].
Better yet, you can easily spread the PWM energy evenly over the period, to minimize external circuitry hassles. Better yet - no need to jump into FPGA technology, if you aren't already there.
|file: /Techref/scenix/lib/io/osi1/pwm/rampwm.htm, 2KB, , updated: 2008/2/11 15:34, local time: 2019/12/12 05:01,
|©2019 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?|
<A HREF="http://www.sxlist.com/techref/scenix/lib/io/osi1/pwm/rampwm.htm"> PIC/Scenix RAM Table Pulse Width Modulation</A>
|Did you find what you needed?|
Welcome to sxlist.com!
& kind contributors
just like you!
Please don't rip/copy
Copies of the site on CD
are available at minimal cost.
Welcome to www.sxlist.com!