USING ARC RELATIVE TO DRAW ARCS For more information see the PCL 5 Printer Language Technical Reference Manual. LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT EcE Resets the Printer. Ec%0B Enters HP-GL/2 mode. IN; Initializes HP-GL/2 mode. SP1; Selects pen number 1 (black). Even though there is no physical pen, the SP command must be used to enable printing. PA1500,1500;PD; Specifies the starting position as (1500,1500) and puts the pen down. AR0,2000,80,25; Draws an arc with a center point 0 Plotter Units (PLU) in the X direction and 2000 PLU in the Y direction from (1500,1500). Then it specifies an arc section to be 80 degrees (positive angle), with a chord angle of 25 degrees. AR2000,0,80; Draws an arc with a center point 2000 PLU in the X direction and 0 PLU in the Y direction from the current pen position. Then specifies the arc section to be 80 degrees (positive angle), with a default chord angle of 5 degrees. Ec%0A Enters PCL mode. EcE Send a reset to end the job and eject the page. Copyright Hewlett-Packard Co. 1993 The information contained herein is subject to change without notice. Hewlett-Packard shall not be liable for incidental or consequential damages in connection with the use of this material.
|file: /Techref/language/pcl/lj1881.asc, 2KB, , updated: 1993/11/15 16:13, local time: 2018/11/18 22:55,
|©2018 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?|
<A HREF="http://www.sxlist.com/techref/language/pcl/lj1881.asc"> language pcl lj1881</A>
|Did you find what you needed?|
Welcome to sxlist.com!
& kind contributors
just like you!
Please don't rip/copy
Copies of the site on CD
are available at minimal cost.
Welcome to www.sxlist.com!