Hayes commands start with "AT", because it enables baud, parity, and wordlength detection. Has nothing to do with "ATtention". For it to work properly, there has to be a transition at the trailing edge of the start bit. So the low order bit of the first character sent (the one used to measure the start bit width) has to be a 1.
A T 0100001 01010100
Notice that the A has only two one bits and they are 7 bits apart (not all serial system support 8 bit transfers) and the T has an alternateing bit pattern with the last bit set off.
Conveniently, the US ASCII character carriage return also has the low order bit set.
|file: /Techref/modem/commands.htm, 1KB, , updated: 2009/12/22 15:17, local time: 2023/5/28 07:07,
|©2023 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?|
<A HREF="http://www.sxlist.com/Techref/modem/commands.htm"> Modem Commands</A>
|Did you find what you needed?|
Welcome to sxlist.com!
& kind contributors
just like you!
Please don't rip/copy
Copies of the site on CD
are available at minimal cost.
Welcome to www.sxlist.com!