Language Pcl LJ1887.ASC

DRAWING LINES IN HP-GL/2

     
     For more information see the PCL5 Printer Language
     Technical Reference Manual.
     
     LEGEND: Ec = [Ctrl] [P] Esc] in DOS EDIT
     
     EcE                           Resets the Printer.
     
     Ec%0B                         Enters HP-GL/2 mode.
     
     IN;                           Initializes printer.
     
     SP1;                          Selects pen number 1
                                   (Black). Even though
                                   there is no physical pen,
                                   the SP command must be
                                   used to enable printing.
     
     PA0,0;                        Begins absolute plotting
                                   from coordinate (0,0).
     
     PD2500,0,0,1500,0,0;          Specifies the pen down
                                   and draw lines between
                                   the points.
     
     Ec%0A                         Enters the PCL mode.
     
     EcE                           Sends a reset to end the
                                   job and eject the page.
     
     
     
            Copyright  Hewlett-Packard Co. 1993
   The information contained herein is subject to change
                      without notice.
   Hewlett-Packard shall not be liable for incidental or
  consequential damages in connection with the use of this
                         material.

  .